Products

Desoldering / Rework/SMD rework system /Jig

HAKKO FR-870

HAKKO FR-870イメージ

Available in:

  • Japan
  • North America
  • Asia
  • Other Countries
  • LEAD FREE
  • ESD SAFE
  • RoHS
  • Infrared pre-heater that provides the optimal heating effect over the whole workpiece surface
  • Short heatup time realized by use of halogen or carbon heaters improves work efficiency
  • Non-contact system enables its application to double-sided boards
Contact Us
Catalog
Manuals / MSDS / Engineering documents
  • Features
  • Packaging List / Specifications
  • Soldering Tip / Nozzle
  • Replacement Parts / Option
  • Maintenance

Features

Infrared heater lamps provide powerful support for insufficient heat when reworking and mounting post-production add-ons

Entire work surface heats rapidly for instant use and improved efficiency

Six heater lamps let you preheat the whole board in next to no time after turning the power on. Full-board heating and quick temperature ramping let you get the job done quickly when reworking or mounting post-production components to multilayer substrates that require greater thermal capacity. As it does not contaminate the air, the HAKKO FR-870 also offers powerful support for a clean workplace environment in industrial applications.

Fully heated 248 mm x 140 mm work grid
Use each side independently to reduce power consumption.

Quick temperature ramping just like a regular infrared heater. Instant warmth at the flick of a switch. Doesn't contaminate the air.

Non-contact system can be used with double-sided boards

Non-contact system allows preheating of double-sided boards, which hot plates cannot handle.

Non-contact system

Set thermal profiles

Auto mode step-heating method (maximum of three steps/step 1-3) heats PWBs slowly and evenly, letting you transmit 100% of the heat energy from a rework system and soldering iron. You'll never be forced to work with a higher set temperature due to insufficient heat again.

Power Mode
Power mode lets you control heater output using settings from 0% to 100%.		   T/C Mode
Once the temperature of the sensor attached to the board reaches the set temperature, the heater is on-off controlled so that the board temperature can be maintained at the set temperature.
Power Mode T/C Mode
arrow   arrow
Auto Mode
Auto mode provides three steps (Step 1-3) to create an optimal heating profile for the work in question, letting all operators consistently produce work of the same quality. Programs can be set for ten channels in each mode.
Power Mode   T/C Mode
Power Mode T/C Mode

Board attachment system facilitates continuous work

Once a PWB is positioned, boards of the same dimensions can be removed or attached in a single motion.
This design greatly facilitates continuous work.

feature1 feature2 feature3
Adjust screws to match board width and length. Boards are hot after operation and must be handled with care.

Convenient design for easy everyday maintenance

The reflector plate can be removed by simply removing the four screws on the base of the unit.
This simple design makes it easy to clean flux and components that have dropped onto the reflector plate.

Convenient design for easy everyday maintenance