Lineup
Fume Extractor/Air-Purifying Type
Available in:
The life of new filters will be approx. 4 times longer compared to FA-430 which employs HEPA* filter. (High Efficiency Particulate Air filter)
Caution
The Hakko FA-431 Fume Extractor is specially designed for use in the electronics soldering process by extracting the contaminated air directly at the source.
Some processes may involve the use of highly corrosive substances or organic solvents. These processes are not recommended for use with the FA-431.
With the use of sub-filter, the life of pre-filter and main filter will be approx. 10 times* longer!
Recommended for auto-soldering application for less frequency of changing sub-filter.
Recommended for hand soldering application for easy and quick change of sub-filter at nozzle.
With a remote control, now it is very easy to switch ON/OFF the unit which is placed under the table.
Exhaust noise has been reduced without sacrificing suction performance by the addition of a silencer unit to the exhaust outlet to ensure smooth air outflow. A high-performance motor with 1,500 Pa of static pressure provides powerful suction and quiet operation.
Noise level dB(A) |
Air volume m3/min |
|
---|---|---|
HIGH | 53 | 4.7 |
MEDIUM | 50 | 3.7 |
LOW | 44 | 2.8 |
*Values measured when the unit was used with a 60 Hz power supply.
Is your smoke absorber affected by air conditioning? Are you fed up with having to re-adjust ducts after every line change? The FA-431 fume extractor is the answer to your problems.
Three airflow modes are available: High, Medium, and Low. Significantly improve your working environment by using an airflow volume that suits the worksite and the job.
Smoke flows in unexpected directions due to a variety of factors; not just because of the influence of air conditioning. High mode is recommended if your worksite is situated near a doorway, in a spot where people continuously pass by, near the exhaust outlet of a large machine, or in a similar location. It is possible to use low mode in laboratories and other places where these kinds of influences are limited.
Ducts can be bent or lengthened as desired and maintain their shape after adjustment, letting you place them exactly where suction is needed. Say goodbye forever to ducts that are long, heavy, and hard-to-handle.
Length | Weight | |
---|---|---|
Duct for FA-431 | 1.2m | 0.6kg |
Small photo on left circled in red:
Bends and stretches freely for perfect placement!
Large photo on left:
Lightweight and compact, the FA-431 weighs only 7.2 kg. Built-in handles allow the fume extractor to be moved easily, facilitating line changeovers.
* The picture is FA-430, which employs HEPA filter.
If the duct is mounted at an angle above the workpiece, it is easily affected by air conditioning
If the duct is mounted directly above, it can be difficult to see the workpiece
Duct is mounted on the worktable to provide excellent suction performance