Top of Products > Fume Extractor Auto-Soldering System Soldering Iron Solder Feeder Thermometer / Soldering Tester Tip Cleaner / Iron Holder Solder / Flux Fume Extractor Soldering Pot Desoldering / Rework Rework Station Static Control Vacuum Pick-Up Tool Tool for Lead and Wire Heating Machine / Heating Gun Glue Gun / Sealer Hobby > Air-Purifying Type > FA-430
Fume Extractor/Air-Purifying Type
FA-430 provides excellent filtering efficiency, 99.97% of particles greater than 0.3μm, by HEPA filter.
No matter how sophisticated a fume extractor is, if the filter is not replaced at the right time, it will not be able to give maximum performance. The FA-430 detects the number of fan rotation and notifies the operator of the appropriate time to replace the filter, guaranteeing a comfortable working environment.
When the pre-filter is 80% clogged or has been used for 200 hours, the orange indicator flashes on and off.
When the 10th pre-filter needs replacing, the orange and red lamps flash on and off.
Exhaust noise has been reduced without sacrificing suction performance by the addition of a silencer unit to the exhaust outlet to ensure smooth air outflow. A high-performance motor with 1,500 Pa of static pressure provides powerful suction and quiet operation.
*Values measured when the unit was used with a 60 Hz power supply.
Is your smoke absorber affected by air conditioning? Are you fed up with having to re-adjust ducts after every line change? The FA-430 fume extractor is the answer to your problems.
Three airflow modes are available: High, Medium, and Low. Significantly improve your working environment by using an airflow volume that suits the worksite and the job.
Smoke flows in unexpected directions due to a variety of factors; not just because of the influence of air conditioning. High mode is recommended if your worksite is situated near a doorway, in a spot where people continuously pass by, near the exhaust outlet of a large machine, or in a similar location. It is possible to use low mode in laboratories and other places where these kinds of influences are limited.
Ducts can be bent or lengthened as desired and maintain their shape after adjustment, letting you place them exactly where suction is needed. Say goodbye forever to ducts that are long, heavy, and hard-to-handle.
|Duct for FA-430||1.2m||0.6kg|
Small photo on left circled in red:
Bends and stretches freely for perfect placement!
Large photo on left:
Lightweight and compact, the FA-430 weighs only 7.5 kg. Built-in handles allow the fume extractor to be moved easily, facilitating line changeovers.
If the duct is mounted at an angle above the workpiece, it is easily affected by air conditioning
If the duct is mounted directly above, it can be difficult to see the workpiece
Duct is mounted on the worktable to provide excellent suction performance
Install the pre-filter inside the frame of the main filter as shown in image 1.
Be sure to check that there are no gaps at the corners as shown in image 2.
If the pre-filter is not installed properly as shown in images 3 and 4, the main filter will degrade its original performance quickly.
|NEW||Product within 1 year after launch|
|DISCONTINUED||Product discontinued already.
The information in this page is based on the data when it was discontinued.
No update/amendement will be added to the page.
|Product that complies with the regulated values of 10 substances prohibited by the european rohs directive.|
|Based on the electrostatic attenuation test (MIL-STD-3010A Test method 4046), products with a charging voltage of 50V or less as being grounded are considered as ESD SAFE countermeasure products.|
|Recommended for work using lead-free solder.|