Select Tip Shape

Select Tip Shape

Search by Tip Shape

How to use Shape J and examples

This shape differs from Shape B and I by bending the tip end and is capable of soldering by applying the tip in 2 ways: face and point. It is used for drag soldering and correction of bridging.


Soldering tiny chip parts such as 0603

Use it for soldering tiny chip parts such as 0603.
Enlarge the tip end,

You can hold the grip with the natural angle (Refer to A) while soldering with Shape J, which has the same high-angle of tip end (Refer to B) as Shape I.

Use it for soldering tiny chip parts such as 0603. Use it for soldering tiny chip parts such as 0603.
Shape J Shape I

Drag soldering

Use it for drag soldering.

Lay down the end pad section and drag the tip slowly.

Apply flux to leads and land pads before soldering. It prevents the troubles such as solder bridge.


See the movie for further details,
    Check the right timing to feed solder.


Correcting Bridging

Use it for correcting Bridging.

If the bridge amount is small

Stand the tip on end and drag the tip slowly.

Please operate with clean tip.


See the movie for further details,

Use it for correcting Bridging.

If the bridge amount is large

Lay down the end pad section and drag the tip slowly while putting the tip on the solder in the bridged section.

Please operate with clean tip.


See the movie for further details,

The operating bellow is also available.
The operating bellow is also available.