Low Cost Intelligent Automation
A smart way to build an auto-soldering system

FU-500 / FU-601 can be combined with various robots and other actuators to build an automatic soldering process at low cost.

• The robot part is not included in this product.

FU-500　Solder Feed Unit

Accurate solder feeding

The compact drive unit is designed to be set beside the iron part for superior repeat accuracy of solder feeding due to the short distance from feeder to tip.

Countermeasure for solder ball scattering

Countermeasure against solder ball and scatter of flux is equipped as standard.
Solder wire diameter can be changed by simply replacing the pulley unit.

Supports solder diameters from Φ0.3 to Φ1.6 mm

Using of 0.3mm dia. solder wire makes micro soldering possible.

2 types of feeder units

Select the one according to your robotic system.

• 

  Straight type

• 

  L type

Easy adjustment of solder feeding position

Solder feeding position, which is a critical point for auto-soldering, can be easily adjusted by turning the screw.

Solder feed error detection

Solder clogging and run-out can be detected with an optical sensor for solder movement.

HF-600　Soldering Iron Unit

400 W Ultra Power

20% performance increase compared to previous models.
HF-600 improves work efficiency for workpieces that were previously difficult or time-consuming.

Maintaining its compact design

Tip size remains at Φ10.5 mm even with increased wattage.

Three types of tips available

TX1 (140 W), TX2 (300 W), TX3 (400 W) can be used interchangeably based on the workpiece.
The display shows the tip in use.

Addition of TX3 tip lineup

The TX3 (400 W) series includes 50 types of tips, allowing you to choose the best one for your workpiece.
New shapes are also available, which is for improving takt time and quality.

Click here for TX3 series tip

Supports N₂ Soldering

Utilizing N₂ gas enhances solder spread and provides a preheating effect, improving work efficiency.

External output function

Ethernet communication, allowing for remote configuration changes and data output such as tip temperature during soldering.
(LAN cable is not included)

Automatic temperature correction/calibration via infrared communication

Using thermometers (FG-100B, FG-101B), measurement results can be sent to the main unit for automatic temperature correction / calibration.
Measurement results can be also saved as data, by connecting to a PC.

Software is required to save data.
Click here to download the HF-600 software.

• To download the software, both "user registration" and "product registration" are required.
  Click here for "user registration" and "product registration".

Compatible with HU-200

By switching the soldering unit to the HF-600, HU-200 can be used as '400W' soldering unit.