![[HAKKO]](/english/images/common/logo.png){kind=logo}
- Easy-to-carry battery-powered soldering iron powered by AA alkaline batteries
- Cordless design makes this iron very handy to use virtually anywhere
- Recommended for hobby handicrafts such as stationary models and radio-controlled models
- Home
- Products
- Soldering Iron
- Ceramic Heater Type
- HAKKO FX-901
Soldering Iron/Ceramic Heater Type
Available in:
| Cool design of cordless soldering iron | |
|
Quick&easy soldering tip replacement ·The quick-release soldering tip can be easily replaced. |
|
|
Selective battery ·Various batteries including alkaline and nickel-hydrogen batteries can be used by changing the cartridge. |
|
|
Easy soldering not only for hobby but for P.C. board processing ·Powerful cord and handy cordless soldering iron. ·Various soldering application is available such as P.W.B., field service and model or radio-controlled models. |
| 1. |
INITIAL SET UP Put the soldering tip through the hole in the nipple, then insert them to the unit as shown in Figure 1. Turn the nipple approximately 90 degrees clockwise and screw it tightly on the unit. Be sure to secure the tip tightly. Attach the soldering tip while it is cold. |
| 2. |
INSERTING THE BATTERIES Slide down the release button to the UNLOCK position as shown in Figure 2. Remove the battery cartridge from the unit. Check the polarity and insert the batteries in the proper orientation. Place the upper side of the battery cartridge onto the guide of the unit, slide the cartridge, and set the release button to the LOCK position. |
| 3. |
HOW TO SOLDER Turn the power switch ON. The LED lamp lights up, and the soldering tip heats up to be soldered after 40 seconds. After soldering, be sure to turn the power switch OFF and attach the protective cap to the unit. |
