HAKKO

News & Topics

Home  >  About HAKKO  >  News & Topics  >  Additional Optional Parts for Tip Cleaning of Auto-Soldering System

Additional Optional Parts for Tip Cleaning of Auto-Soldering System

2021/12/16New Products

Two optional parts are now available for tip cleaning of the Auto-Soldering System.

 

Cleaning Brush/Silicone brush

Best suited longlife cleaning brush, for the Auto-Soldering System that performs high-volume soldering.

Fitted with silicone brushes (without solder waste collector)
  • Less solder stick to the brush because of silicone material.
  • Silicon brush is more supple and durable than the steel material.

Approximately 21 times longer than the standard brush  (Part No.A1567) made of steel.
*Based on our in-house test

 

Cleaner Positioning Board

Having the cleaner positioning board allows rotating the positioning of the tip cleaner by 90 degrees.

Tip cleaner placed without a cleaner positioning board
(without solder waste collector)

 
Tip cleaner placed with a cleaner positioning board
(without solder waste collector)

 

Rotating the position of the cleaner by 90 degrees makes it possible to use not only the Z-axis and θ-axis but also the X-axis during cleaning.
Therefore, cleaning into the deep inside of the groove and on both sides of the tip surface becomes possible, since the tip straddles the brushes in the X-axis direction (right and left).

K-shape soldering tip before the cleaning
K-shape soldering tip after the cleaning
Cleaning with the cleaner positioning board The deep inside of the groove becomes clean.
Cleaning without the cleaner positioning board Some solder remains inside the groove of the tip.

HU-200 can register multiple cleaning positions to the system.
Then, it is possible to call the multiple cleaning positions arbitrarily by the program.
This function increases the degree of freedom in designating the cleaning position. And by using a metal brush and a silicone brush properly, it is possible to perform a cleaning that achieves both oxide removal and long-life characteristics.

Fitted with a standard brush and a silicone brush
 (without solder waste collector)
Standard parts
Cleaning Brush B/Metal brush (Qty:2)
(Part Number A1567)

The cleaning positioning board can be attached to the jig table of the Y-axis with the screws provided as the accessories. So, it contributes to shortening the moving distance for cleaning.

Attaching the board to the jig table of the Y-axis 1
(without solder waste collector)
Attaching the board to the jig table of the Y-axis 2
(without solder waste collector)

Details of Auto-Soldering System HU-200 from here.
Auto-Soldering System HU-200