 |
 |
|
|
|
|
|
|
|
|
|
|
 |
|
"Maintenance kit for
oxidized soldering tips"
Especially suitable for soldering tips oxidized by Lead-free solder and
high temperature solder
By using the brush and accessory "Chemical Paste"HAKKO FS-100:
|
|
Oxidation can be removed without
causing damage to the soldering tip |
|
Diamnonium phosphate is not
included |
|
Power saving with 3 power
consumption. |
|
| Part No. |
Packing List |
| No.FT700 |
HAKKO FT-700 Tip Polisher, HAKKO FS-100
Paste, Brush: 1pc each |
| Part No. |
FT700 |
| Power Consumption |
3W |
| Outer Dimensions |
70(W) x 54(H) x 101(D)mm |
| Weight |
0.65kg |
|
| Part No. |
Name |
| HAKKO FS-100 |
Chemical paste |
| B3051 |
Brush |
| B3052 |
Polishing Brush (2pcs) |
|
1.Plug in the power cord.
2.Turn on the power switch.
3.Touch the oxidized tip to the polishing brush to remove the oxidation
film.
(Tip temperature 300ºC is the most suitable for clean, however, the
cleaning can be performed at temperature between 300 to 400ºC.) |
BEFORE
Oxidized tip
|
Eliminating oxidation film
 |
|
Quickly apply solder tinning again
|
AFTER
Polished and retinned tip
|
Feed the solder wire to the tip |
| NOTE: |
When the tip temperature is over 400ºC,
even if the oxidation film is removed by "HAKKO FT-700 tip polisher",
the tip can turn to be oxidized quickly again. |
| When the oxidation film cannot be removed
by the above procedure: |
| When the oxidation is hard, it sometimes cannot be removed
even by the HAKKO FT-700. In this case, use the brush which is included
in the unit as the accessory. |
 |
|
|
|
 |
| (1) Remove oxidation the brush. |
|
(2) Clean with FT-700 |
|
(3) Retin with HAKKO FS-100 |
| NOTE: |
When the brush is used, small scratches may be
produced on the iron plating surface of the tip.
Do not always use the brush, but use only when oxidation cannot be removed
by cleaning with HAKKO FT-700. |
|
|
|
|
|
|
What's lead-free?
What's European RoHS?
