Thank you for choosing HAKKO.

HAKKO has confirmed that in certain circumstances solder may spatter small solder balls out of the HAKKO FX-301 when the power is turned on.

This symptom occurs as the solder melts when the temperature rises if the power is turned on under the following conditions:

• - When using eutectic solder
• - When solder is from 6 to 12 mm below the top surface of the solder pot

* Solder spatter has not been confirmed when using lead-free solder or when the solder pot is full to within 5 mm of the top surface. Usage Precautions for HAKKO FX-301

As a countermeasure for this issue HAKKO is distributing solder spatter prevention covers free of charge. See the chart below for applicable serial numbers and how to apply.
After turning the HAKKO FX-310 on, the solder spatter prevention cover should be put on until the display stabilizes at the set temperature (when the display varies from flashing to lit at the set temperature.).

Using the solder spatter prevention cover		Use the spatula attached at point of purchase.

Applicable Product	HAKKO FX-301
Distribution Period	October 1, 2007 - March 31, 2008
Applicable Serial Numbers	Check the last seven digits of the serial number. No. xxxxx4000001 - xxxxxxxxx7001999 * Serial numbers will have a total of either 12 or 16 digits.
Request Method	Make an application via the following webpage: Solder Spatter Prevention Covers - Free Distribution Request
Click here for further inquiries.