The problem in which the flow force becomes weak and a block of black oxides is discharged can be prevented by periodic overhauls. In addition, seizure of screws can be prevented.
Assembly
Assemble the bath according to the following procedures.
1. Assemble the chamber, impeller and bottom plate.
No screws are required for assembly. Only press-fitting the bottom plate into the chamber is required.
2. Install the anti-oxidizer plate in the chamber.
3. Insert the joint onto the impeller.
Note that the installation direction of joint is specified.
Insert while referring to the figure at right. In this case, it is unnecessary to tighten the screw.
4. Install the chamber in the bath. (Tool to be used: Pliers)
7. Check that the impeller does not come in contact with the chamber by turning the joint with fingers.
If the joint does not rotate smoothly, check the following points.
1. Perpendicular misalignment in joint connection
2. Horizontal misalignment in anti-oxidizer plate
Assembly
If the joint does not rotate smoothly, check the following points.
