Maintenance Method for
Flow soldering system HAKKO 485
|
 |
| The problem in which the flow force becomes weak and a block of black oxides is discharged can be prevented by periodic overhauls. In addition, seizure of screws can be prevented. |
|
Preparation for work |
If the joint and nut are secured as shown in the photo, work according to the following procedures.
|
| |
| 1. Turn on the power and wait for a while until solder is melted. |
|
|
| |
| 2. Face the joint toward the front so that the screws on the joint can be seen. |
| |
 |
| |
| 3.Suck up solder until the nuts can be seen completely. |
| |
 |
| |
| 4. Turn off the power and wait until solder has rehardened. |
| |
| 5. After solder rehardened, disassemble and perform cleaning. |
| |
|
|
|
|
